Raymarine forum / Raymarine Forums / Multifunction Displays v / Yamaha command link engine ID problem

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Yamaha command link engine ID problem
12-13-16, 11:10 AM (This post was last modified: 12-13-16 02:26 PM by Chuck - Raymarine - Moderator.)
Post: #21
Bhngh Offline
Junior Member
**
 		Posts: 21
Joined: Mar 2016
Reputation: 0
RE: Yamaha command link engine ID problem
I successfully got the V1.12 on to the ECI-100. I'm sure that all mfd settings are at
2 engines. (customize etc)
I can ID both engines. When I start the port engine it comes up fine on the engine data screen. Then when I start the starboard engine it comes up fine on the data screen.
At that point the port engine data locks up and then disappears.
I've tried going through all steps several times.
At one point before I started installing updates to Raymarine E127 I was getting both engines to read data just fine.
I need a hug and a hat at this point.
What's next?
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Yamaha command link engine ID problem - Bhngh - 12-13-16 11:10 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication