Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
VRM/EBL on a ES127
01-17-17, 11:10 AM
Post: #2
RE: VRM/EBL on a ES127
Welcome to the Raymarine Forum Mike

The Radar application's VRM/EBL is designed to provide range and bearing information to selected target images within the Radar application's display. The VRM/EBL may be configured on by either holding your finger pressed atop the radar target image and then selecting PLACE VRM/EBL from the displayed Radar menu. Alternatively, the UniController's pointer may be used to position the cursor over the radar target image, the OK button pressed, and then selecting PLACE VRM/EBL from the displayed Radar menu. Range and bearing (relative to the vessel's head) will be reported within a red boxed area adjacent to the radar target. Moving the VRM/EBL to another location is accomplished by simply touching the Radar application's display in another location.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
VRM/EBL on a ES127 - Mikefossl - 01-16-17, 10:23 PM
RE: VRM/EBL on a ES127 - Chuck - Raymarine - Moderator - 01-17-17 11:10 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)