Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Adding a RAY70 AIS VHF
01-25-17, 04:57 PM (This post was last modified: 01-25-17 04:58 PM by Chuck - Raymarine - Moderator.)
Post: #4
RE: Adding a RAY70 AIS VHF
Festinalente,

The terminology regarding how you have interfaced the "E90w display ... with a radar, GPS and sounder with the help of a seatalk HD using rg45 cable" is not correct. Raymarine has produced no products using the "SeaTalk HD". The E90W would have been interfaced to the radome or open array pedestal via Ethernet communications. The GPS sensor (make/model not specified) most certainly would have not been interfaced to the MFD via Ethernet communications. Depending upon the make/mode of sounder installed onboard (these have not been specified), it may or may not have been interfaced to the MFD via Ethernet communications.

Should there not presently be a SeaTalkng backbone installed onboard, then it will be necessary to install the SeaTalkng Power Cable which had been supplied, as neither the MFD nor the Ray70 are designed to supply power to a SeaTalkng/NMEA 2000 backbone.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Adding a RAY70 AIS VHF - Festinalente - 01-17-17, 12:32 PM
RE: Adding a RAY70 AIS VHF - Chuck - Raymarine - Moderator - 01-25-17 04:57 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)