mfd eseries not showing waypoint info correctly in databoxes

[glenngustafson]

I have an e95 at my helm and an e125 at my nav station. After I did last falls upgrade, I noticed that my display is not showing the correct data in the databoxes I have programed into these displays.

I have data boxes programed to show cursor range and bearing and waypoint info (bearing and distance) .

When I boot up, cursor distance is shown, but not the bearing. It just shows --- degree m. I have to turn the display off and on to get it to display this info. Also, if I hit the home key and select the chart/data display, the Crs Rng & brg will show up if I switch back to the chart only application. Something is amiss in your program. This data always used to come up from a cold boot and no refreshing is needed.