Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Raymarine Smart Pilot S3G
06-20-17, 12:16 PM (This post was last modified: 06-20-17 01:14 PM by Chuck - Raymarine - Moderator.)
Post: #5
RE: Raymarine Smart Pilot S3G
Hello Chuck,
Further to your last e mail.
I contacted Martek and spoke to a guy called David Gratton and asked them to give me a quotation to supply and install on two occassions but they never replied to me.

Going back to the install thank you for confirming that I need the T70162 EV -400
Also the Sea Talk convertor kit E22158.

My final question is:
What do I need to hook the EV-400 to the Raymarine C120 Classic chart plotter.
I think the existing S3G has an NMEA 2000 connection to the C120 Chart Plotter.?

I assume the 2 existing Sea Talk cables are ones that go to both existing control heads ST1002
One of these will be replaced with a new p70RS.
As I mentioned I would like to keep the existing ST1002 head on the fly bridge as I cannot run new cables so I need the convertor kit E22158 for this.

However what about the NMEA connection to the C120 Chart Plotter.?
There is two leads coming out of the NMEA 1 block on the S3G A WHITE + WIRE AND A bROWN -VE i ASSUME THIS IS GOING TO THE c12 ?
Do I need a R08004 connector for this.

I have tried to upload some photos but owing to the size restriction it was immpossible.


Thanks a million,
Stephen.


Attached File(s)
.pdf  S3G.pdf (Size: 709.89 KB / Downloads: 335)
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Raymarine Smart Pilot S3G - phantasy - 05-26-17, 11:53 AM
RE: Raymarine Smart Pilot S3G - phantasy - 06-20-17 12:16 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)