The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error





Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Raystar 130 retro kit to C80
06-08-17, 02:29 PM
Post: #1
Raystar 130 retro kit to C80
So I just purchased a T70133 kit to replace my failed RN300 system. I have a C80, radar, Auto pilot and st6001 controller and the Failed RN300 that I plan to do away with completely on a 22' C-Dory.
It looks simple enough to hook this up except for the fact that my system has neither a D244 junction block or a R55006 that is shown in the instructions diagram. Instead it has a generic marine terminal bus that the wires from all said components are screwed in to. There is not a dedicated power wire going in to the terminal so I must assume that power is being supplied from either the Auto pilot, C80 or RN300.
I am not sure of how to disconnect the current power input so that I can supply power through the SeaTalkng converter to the system. Any help with this would be greatly appreciated.

Thanks

Doug
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Raystar 130 retro kit to C80 - drbridge - 06-08-17 02:29 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)