Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
RL70C not communicating with RC631
06-09-16, 06:11 AM (This post was last modified: 06-09-16 07:47 AM by Chuck - Raymarine - Moderator.)
Post: #16
RE: RL70C not communicating with RC631
Chuck, I did as you said and disconnected the red lead from the st1-stng converter to the autopilot but left the yellow and silver connected. I also left the yellow,silver and red connected from the 400g to the st6001 control head. However when doing so, I lost all power to the control head.

Only when I put the red lead from the st1-stng converter back onto the 400G did it power the ST6001 control head.

With that configuration, i could get the mfd to turn the autopilot on and off but i had a seatalk fail showing at the control head so had no way of adjusting the parameters of the autopilot.

Is the 400G actually supplying power to the buss or is it just passing it through?

Where should i go from here?
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: RL70C not communicating with RC631 - dkritter - 06-09-16 06:11 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)