[CA] [CA11] Bennett NMEA1 (N2K) trim tabs & the AXIOM 9rv

[Thebobman]

I am still trying to accomplish a way to have my Axiom 9RV display my Bennett Trim Tab position. I am in the same position as others where I have installed the NMEA2000 indicator, the Axiom sees it is there, but I cannot calibrate. I came across this post:

http://www.boat-project.com/nav/n2000.htm

Would it be safe to assume if it worked on the C80 mentioned there that it would work on the Axiom? Also, If I were to put an LMF 200 in the system, calibrate the tabs, then remove the LMF 200, would that calibration stay in the "system" or does it go away with the LMF 200?