The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error





Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] Issues w Fishfinder and Axiom MFD
12-02-17, 07:16 PM (This post was last modified: 12-06-17 02:02 PM by Chuck - Raymarine - Moderator.)
Post: #1
[CA] Issues w Fishfinder and Axiom MFD
I have recently upgraded my Raymarine network.

Axiom 9" x3 - new 2 months and updated before install
CP370 - new this year
Airmar M260 in hull - 12 yrs old

When the Axioms were installed all worked w fishfinder properly.

Occasionally the fishfinder would lose the bottom and read sporadic shallow depths w a confused screen while in 125' of water. Usually within minutes this would pass and return to normal.

A couple of weeks ago, it did the same thing but would not return to normal after an hour. I unplugged the transducer from the CP370 and plugged it back in to try to see if that would help. The MFD never detected the transducer after that and I dont believe the ducer was powering up after that.

I assumed the transducer was damaged so I purchased a new one and hooked it up to the network and it did not turn on.

I replaced the CP370 to see if that was damaged and no change. Still not working.

I swapped out network cables to test and still nothing.

Im not sure where to go next on this

Any suggestions?
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA] Issues w Fishfinder and Axiom MFD - moonzy1 - 12-02-17 07:16 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)