Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
(DG) New Spx10 calibration/setup
01-18-18, 12:23 PM
Post: #2
RE: (DG) New Spx10 calibration/setup
Hi jono63812
thank you for your enquiry.

The SPX versions of Autopilots have a RESET option in the calibration, there is no problem using this, just remember that it will reset everything in the pilot to the default values that are preset when the unit leaves the factory. So you will need to set up everything, vessel type, drive type, rudder limits etc. etc . . . . , it is not difficult, but just take your time and be methodical.

This link click here helps explain some parts of the calibration with regards to compass location.

This link click here helps explain the rudder angle calibration.

regards
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: (DG) New Spx10 calibration/setup - Derek - Raymarine - Moderator - 01-18-18 12:23 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)