Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] Seatalk-ng Coverter Power
02-08-18, 12:02 PM
Post: #2
RE: [CA] Seatalk-ng Coverter Power
Welcome to the Raymarine Forum glencoeboy,

As has been quite consistently recommended within this Forum's staff, it is recommended that SeaTalkng backbones not be powered from a SeaTalk bus via a SeaTalk to SeaTalkng Converter. Should the SeaTalk bus be interfaced to a legacy autopilot (ex. S2G, ST4000+, ST2000+, etc.), then the red lead of the SeaTalk cable connecting the autopilot course computer's SeaTalk port to the SeaTalk bus will not be used. In this case, the red lead of this SeaTalk cable should be disconnected from the autopilot course computer's red SeaTalk terminal. This red lead should then be insulated to prevent shorting.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA] Seatalk-ng Coverter Power - Chuck - Raymarine - Moderator - 02-08-18 12:02 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)