Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] Possible CPT-200 Transducer Low Voltage Issue
03-19-18, 12:22 PM
Post: #4
RE: [CA] Possible CPT-200 Transducer Low Voltage Issue
Tom,

The symptom which you have described is normal. The specified alert will be displayed if CP200 is powered ON after the MFD has completed its startup initialization. Clearing the alert will then permit SideVision sonar imaging to proceed. This message would not typically be encountered if the MFDs and CP200 were switched ON at the same time.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA] Possible CPT-200 Transducer Low Voltage Issue - Chuck - Raymarine - Moderator - 03-19-18 12:22 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us