The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error





Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] Axiom Pro Heading Data from Autopilot
03-20-18, 06:34 AM (This post was last modified: 03-21-18 10:33 AM by Chuck - Raymarine - Moderator.)
Post: #1
[CA] Axiom Pro Heading Data from Autopilot
Just completed installation of 2 new Axiom Pro MFDs, with i60/i50 + i70s instruments, iTC-5 for all the transducers.

There is currently a Simrad J300x-40 autopilot installed in the boat.

For whatever reason I can NOT get heading data on the Axiom Pros.

Tried using the 0183 Tx/Rx ports straight to the 16" Axiom Pro which didn't work so I used an Actisense NGW-1 we had on hand. Directly connected the NGW-1 to the Tx/Rx port 2 on the J300x then adapted the DeviceNet cable to my STng network.

On the Axiom Pro I can go to Settings> Network> Data Sources I can select the iTC-5 for the depth, wind etc but for Heading it won't detect any source.

However, on the i70s instrument I can go to Menu> Set-Up> System Set-Up> Data Sources> Heading I can choose between "Auto" and "NMEA2000<_>018"
This allows me to get Heading on the i70s so I know it's available on the STng backbone.

Any thoughts?
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA] Axiom Pro Heading Data from Autopilot - Kevin - 03-20-18 06:34 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)