Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] AIS650 to C90W connection
07-08-18, 05:03 PM
Post: #9
RE: [CA11] AIS650 to C90W connection
Chuck,
I have this figured out now and would like to pass on my learnings.

The AS650/AIS100/C90W system is working well. However ; the 'non-tranmission' issue arises because every time the C90W is turned on, the default setting for the AIS is "SILENT MODE" set to ON. Therefore, I need to go into the MENU -> AIS LAYER SETUP -> SILENT MODE and set this to OFF. The default setting is ON otherwise. If I neglect to do this the AIS remains in SILENT mode throughout.

To be clear, I have not connected up a Silent Mode hardware switch.

IMHO, I think it would be better if the software was set to default SILENT MODE = OFF or even latched to the previous setting rather than as described.

Jim
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: AIS650 operation - jim5099 - 06-10-18, 01:28 PM
RE: [CA11] AIS650 to C90W connection - jim5099 - 07-08-18 05:03 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)