Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[TG] Axiom Fuel Manger and G/hr - fuel consumption the same for each engine
05-16-18, 10:29 PM (This post was last modified: 05-17-18 09:46 AM by Chuck - Raymarine - Moderator.)
Post: #2
RE: [TG11] Axiom Fuel Manger and G/hr - fuel consumption the same for each engine
Hello qbayle,

If the data items you're looking at are Engine Fuel Rate (1) and Engine Fuel Rate (2), this should be what's coming directly from the relevant engine over NMEA2000. If you're seeing a single common value, that's usually because the transmitting device isn't sending correct data. It's not an MFD configuration or setup issue.
This could be that the transmitter is summing, or perhaps is sending two messages with the same engine Instance number (Instance is the first data item in each engine message and tells the receiving device which engine the data applies to, where 0=Port and each subsequent engine is numbered from there.)
Engine RPM is sent in one message (127488, Engine Parameters Rapid Update) whereas fuel flow rate is sent in another (127489, Engine Parameters Dynamic) so it is possible that you could have correct Instance identification in one and not the other.

We can understand what's going on either by doing some practical tests on-boat, or by having the NMEA2000 raw data recorded and sent in to us for analysis:

The simplest on-boat test would be to run Port, observe the fuel-flow rate displayed in each data item, then stop Port and run Starboard, then run both together. You'd expect, of course, to see zeroes or dashes for whichever engine wasn't running, and approximately the same value for each when both are running as when only one is running. If that's not what you see, let us know what results you do get and we can work out what's going on.
Another test would be to look at any of the other data sent in the same message (127489) as fuel flow rate: almost everything engine-related except for RPM, Boost Pressure and Tilt/Trim is sent in 127489, so how do oil pressure/temp, coolant pressure/temp, alternator voltage, torque/load or operating hours look?

On the other hand, the other way would be for someone to look at the raw NMEA2000 data. You can't (yet) record this data with the Axiom display, but many technical dealers will either have a PC interface that can do so, or a Raymarine Lighthouse 2-generation display that can. Either way, if you can get a log-file of the NMEA2000 data, I'd be happy to have a look.

Regards,
Tom

Raymarine since 1999.
Interests: Diagnosis of problems in sonar/fishfinders, NMEA2000, ethernet comms, autopilots, thermal cameras
Location: Sydney, Australia.

Please don't PM me asking for direct support, please ask a public question instead so that others can see the question and answer. Forum posts will always be answered before PM requests.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [TG11] Axiom Fuel Manger and G/hr - fuel consumption the same for each engine - Tom - Raymarine - Moderator - 05-16-18 10:29 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)