The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error





Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] PROBLEM WITH ES97
06-09-18, 03:06 AM (This post was last modified: 06-13-18 01:01 PM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] PROBLEM WITH ES97
I have an ES97, CP370 Quantum Radar, P70r, RS-150, EV-1, ACU200 and
Ray70. Everything has been working great and then about 1 hour into my trip today I suddenly start getting alarms - no heading, no AIS, etc. It seems the Seatalk network dropped out from the ES97 and it could not communicate with the RS-150(No GPS), or the Ray70(NO AIS) or the P70R(No Autopilot). However, The P70R was working just fine and communicating with the ACU200, EV-1 and the RS-150 (shows active). I checked the cable and it was fine. I tuned the unit off, waited a few minutes and turned it back on again. Everything started working again, but then a few minutes later - same thing. I tried unplugging the RS-150 - same thing happened. I tried unplugging the Ray-70 - same thing happened.

Is there anything else I should try? My gut tells me that my ES97 has gone bad for the third time...
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA11] PROBLEM WITH ES97 - DFMott - 06-09-18 03:06 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)