[CA] [CA11] Upgrading from SL70 to ev200 and E127’s

[markdd3880]

Hi Chuck
Have the whole installation pretty much complete thanks for your help!
I have a problem getting the autopilot heading to get anywhere near the liquid filled compass on board its around 30 degrees out so I need to experiment a little there. The heading sensor core is aligned with the centre line of the boat and deviation has run out to be 17 degrees on 2 separate calibrations and as the deviation around the lake area is about 14 degrees anyway I guess its not far off but have to experiment a little with this.
I wanted you to know that the autopilot deals with transitioning to run on one engine only and holds a heading perfectly. Very impressive because it deals with gradually alternating the drives at 8 knots then steers perfectly up on the plane using both engines at 18 knots. Amazing!
I am presently connecting existing analogue cameras and have a question. I have two E127 mfds and there is one bnc video connection on each of the power leads.
I also have R7003 video leads connected to each mfd and they too have a bnc connector. Does this mean two cameras per mfd can be connected? One onto the power cable bnc and one onto theR70003 bnc? I need 4 camera connections and trying to get by without a switch or network.
Very best
Mark