Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[TG] ES98 and CP120 Transducer - the lightwave nightmare continues
09-23-18, 10:26 PM
Post: #2
RE: ES98 and CP120 Transducer - the lightwave nightmare continues
Hello James,

There is no software in the CPT120 transducer, you don't need to worry on that point. The transducer is auto-detected purely on the basis of a sense resistor signal line in the transducer cable, so I am guessing that either your transducer resistance is borderline or through the upgrade-downgrade process, the auto-detection hasn't worked this time. I'd do a power-on reset on the eS98 first of all, if you haven't already. In order to do so, press and hold the Back key as you power up. I assume you don't have any user data in there at the moment, but if so, make sure you back up all your waypoints/routes/tracks etc. before you do so.

If the reset doesn't solve it, come back to me.

Regards,
Tom

Raymarine since 1999.
Interests: Diagnosis of problems in sonar/fishfinders, NMEA2000, ethernet comms, autopilots, thermal cameras
Location: Sydney, Australia.

Please don't PM me asking for direct support, please ask a public question instead so that others can see the question and answer. Forum posts will always be answered before PM requests.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: ES98 and CP120 Transducer - the lightwave nightmare continues - Tom - Raymarine - Moderator - 09-23-18 10:26 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)