Raymarine forum / Raymarine Forums / Autopilots v / [CA] [CA11] Steering gear impact with rotary drive type 1

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Steering gear impact with rotary drive type 1
10-17-18, 12:18 PM (This post was last modified: 10-17-18 12:19 PM by Chuck - Raymarine - Moderator.)
Post: #2
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
RE: [CA11] Steering gear impact with rotary drive type 1
Welcome to the Raymarine Forum Germain,

Recommended sprocket size is based on number of steering shaft turns required to move the rudder hard over to hard over. Should a sprocket of the incorrect size be used, then too much power may be required from the ACU, the response of the autopilot may be either too fast or too slow, and/or it may also not be possible for the autopilot to properly compensate. Use of sprockets other than those which have been specified may also void the autopilot's warranty.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA11] Steering gear impact with rotary drive type 1 - Chuck - Raymarine - Moderator - 10-17-18 12:18 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication