Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Selecting units not possible after sw update
11-08-18, 09:55 AM
Post: #2
RE: [CA11] Selecting units not possible after sw update
Welcome to the Raymarine Forum Looma,

Within your system, the Master for Depth data is the ST60 Depth or ST60 Tridata Instrument to which the instrument depth transducer has been directly connected. The user interface of this device will need to be used to configure the Depth Units for the system via the User Calibration menu as you have suggested. Updating the a95 MFD's software would have absolutely no effect upon the software of the ST60 instruments and access to their menus. This is because the MFDs can only update the software within compatible products which have either an Ethernet communications interface or a SeaTalkng / NMEA 2000 communications interface. That said, the downloaded compressed folder containing the software update files the MFD also contained software update files for devices which were designed to be updated by the MFD. A SeaTalk to SeaTalkng Converter is an example of one such device. Which versions of software is presently installed within the MFD and within the SeaTalk to SeaTalkng Converter?
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA11] Selecting units not possible after sw update - Chuck - Raymarine - Moderator - 11-08-18 09:55 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)