The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Networking / System Integration v / [CA] [CA11] Autopilot Integration to Seatalkng

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Autopilot Integration to Seatalkng
01-19-19, 11:28 AM (This post was last modified: 01-22-19 10:29 AM by Chuck - Raymarine - Moderator.)
Post: #1
Redman Offline
Junior Member
**
 		Posts: 9
Joined: Mar 2018
Reputation: 0
[CA11] Autopilot Integration to Seatalkng
I've been studying the attached excellent diagram posted by another member and attempting to apply to my own planned setup. In my setup, the S2 autopilot and ST6001 will be the only legacy Seatalk components. Hence the connection from the S2 Autopilot to the ST6001 shown in the diagram is same as mine.
Q1: For my setup, may I connect the ST6001 seatalk "out" plug directly to the Seatalk-Seatalkng converter?
Q2: If I can, I assume that the red power wire at the Seatalk A terminal of the autopilot should be disconnected , correct?
Q3: Mainly for curiosity...in the diagram why isn't the ST6001 daisy chained to the other instruments in order to connect it to the Seatalk-Seatlkng converter?


Attached File(s) Thumbnail(s)
   
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA11] Autopilot Integration to Seatalkng - Redman - 01-19-19 11:28 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication