Raymarine forum / Raymarine Forums / Multifunction Displays v / [CA] [CA11] Use the ECI-100 Universal Engine and Control Interface with our GS Series MFD?

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Use the ECI-100 Universal Engine and Control Interface with our GS Series MFD?
02-16-19, 08:03 PM (This post was last modified: 02-19-19 10:29 AM by Chuck - Raymarine - Moderator.)
Post: #6
jwasko Offline
Junior Member
**
 		Posts: 30
Joined: Dec 2017
Reputation: 1
RE: [CA11] Use the ECI-100 Universal Engine and Control Interface with our GS Series MFD?
Kevin
If you're considering the Mercury Gateway, I found it worked without a hitch to tie my twin QSB 5.9's to my e165 LH2 system. It was a simple matter to plug the gateway into a spare port on one of the Smartcraft junction boxes and the other end into an open STNG spur socket using a Raymarine devicenet adapter cable. All of the data came up immediately for both engines with no configuration or setup required on the MFD other than to pick the individual data items to display. Could not have been easier.
Jim
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA11] Use the ECI-100 Universal Engine and Control Interface with our GS Series MFD? - jwasko - 02-16-19 08:03 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication