Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Use the ECI-100 Universal Engine and Control Interface with our GS Series MFD?
02-22-19, 06:13 PM
Post: #7
RE: [CA11] Use the ECI-100 Engine and Control Interface with our GS Series MFD?
Hi Jim, thank you for the reply. I have not looked into the Mercury Gateway. My Raymarine is 2008-9 vintage G-Series and does not run on the LH2 software. This was their top of the line at the time MFD system. It all works well and I have a window with engine gauges on the MFD so back then it was doable somehow. But time marches on an the knowledge base gets "fuzzy". I was hoping since Cummins engines are so common in the USA that the Raymarine ECI-100 would work on them. Chuck had stated earlier in the thread that Cummins is not on the list now. It is cool that the Mercury Gateway worked with your equipment! I have not seen a NEMA2000 port on my Smartcraft junction boxes. What year engines/ECU do you have? Cheers, Kevin
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA11] Use the ECI-100 Engine and Control Interface with our GS Series MFD? - polingk - 02-22-19 06:13 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)