Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Configure New Network and Incorporate S2 Course Computer
12-11-19, 10:04 AM (This post was last modified: 12-11-19 10:06 AM by Chuck - Raymarine - Moderator.)
Post: #28
RE: [CA11] Configure New Network and Incorporate S2 Course Computer
Scott,

Q1. I looked up the LEN loads and added a few things. I wasn't sure of the LEN loads of the following, do you know?
A1: LEN values below:
T70134 - 0 ... this is a backbone starter kit
E70196 - 1
E22158 - 1
A06064 - 0 ... this is a 5-Way connector

Q2. Also not sure if the S2 Course Computer and Icom VHF had any LEN?
A2. Negative and negative.

Q3. I added the Fusion Stereo and moved the power connection spur over to try and help center the load. As I see it now aside from the above listed...I have 6 LEN on one side and 8 LEN on the other. Is this acceptable?
A3. That's close enough.

Q4a. I also added Quantum 2 Radar in blue since it will be a future purchase but wanted to show the entire system. I believe it only connects to the HS5 Network Switch via Raynet cable so would not have a LEN load on the backbone, correct?
A4a. Correct

Q4b. I also added it to page 2 for its power connection with a 5 amp fuse, correct?
A4b. Correct. Please click here to view a FAQ addressing recommendations for marine electronics power circuits.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA11] Configure New Network and Incorporate S2 Course Computer - Chuck - Raymarine - Moderator - 12-11-19 10:04 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)