[DG11] Raymarine EVO ACU-400 Install

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[DG] [DG11] Raymarine EVO ACU-400 Install

03-15-19, 05:32 PM (This post was last modified: 03-18-19 07:49 AM by Derek - Raymarine - Moderator.)

Post: #1

svbloom Offline

Junior Member

Posts: 38
Joined: Jun 2016
Reputation: 0

[DG11] Raymarine EVO ACU-400 Install

I'm installing the ACU unit for our new EVO autopilot. We are reading the section in the manual about the RF ground but we do not have one. We understood that the ACU was a fairly direct swap with our old Raytheon unit, but the old one didn't have this type of ground. Are we reading correctly that there should be two wires going to the negative bus bar? How can we ensure this new unit is grounded?

« Next Oldest | Next Newest »

Messages In This Thread

[DG11] Raymarine EVO ACU-400 Install - svbloom - 03-15-19 05:32 PM

RE: [DG11] Raymarine EVO ACU-400 Install - Derek - Raymarine - Moderator - 03-18-19, 08:05 AM

User(s) browsing this thread: 1 Guest(s)