[DG] [DG11] dual autopilots and hunting
|
03-18-19, 10:32 AM
(This post was last modified: 03-18-19 11:59 AM by Derek - Raymarine - Moderator.)
Post: #1
|
|||
|
|||
[DG11] dual autopilots and hunting
I recently installed two ACU 400's and two type 3 rams. Obviously only one can be powered at any given time. I daisy chained the two ACU's off of one rudder sensor. One of your moderators indicated that could create problems so I disconnected the second ACU. Both units work perfectly without the rudder sensor, however if I connect the ACU to the rudder sensor it sometimes goes into violent oscillation, perhaps once an hour, more often if the weather is rough. I can stop this by grabbing and briefly holding the wheel. I've run setup as indicated in the manual and ensured that the system is thoroughly bled. Any suggestions.
|
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
[DG11] dual autopilots and hunting - shparrot - 03-18-19 10:32 AM
RE: [DG11] dual autopilots and hunting - Derek - Raymarine - Moderator - 03-18-19, 12:06 PM
|
User(s) browsing this thread: 1 Guest(s)