[CA] [CA11] Yamaha engine data

[Chuck - Raymarine - Moderator]

Willy81,

Thanks for sending the requested data. All equipment within the system appears to be almost up to date with the latest software (LightHouse 3 v3.9.46 was released earlier this week and it would be recommended that the system's MFDs be updated with this software when it is convenient to do so). While I don't suspect that it may be responsible for the reported issue, you may want to consider interfacing the Axiom 7 MFD to the system's Ethernet network to permit a single MFD to be acting as the system's Data Master MFD.

The only other thing which I can recommend to address the reported problem is to factory reset to the ECI-100 and then once again perform the Identify Engines procedure. Should the equipment have been installed by a Certified Raymarine Installer in your area, then I would recommend contacting this installer to reset the ECI-100 and then perform the Identify Engines procedure once again. If the equipment was not installed by a Certified Raymarine Installer, then it would be recommended that the ECI-100 be sent to Raymarine’s Product Repair Center to be reset.