[DG] [DG11] autopilot oscillates back and forth
|
04-09-19, 10:02 AM
Post: #4
|
|||
|
|||
RE: [DG11] autopilot oscillates back and forth
Hi Kmac,
Thanks for the feedback, So if the E120 is connected only via STng, check the backbone is correct with the terminators on the correct places, a steady 13v on the power to the backbone. Try disconnecting the E120 and leaving just the pilot on the backbone, does the pilot operate correctly, display all the correct data? If yes, then try the other E Classic display and temporarily set that to master and test if it will perform the update. It would be a good idea to isolate the E80 completely except for the STng, so disconnect the network connection too, also temporarily disconnect the ST to STng converter so that all the system is connected through a short backbone and with no other items in the network. Thanks Derek |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
[DG11] autopilot oscillates back and forth - Kmac - 04-08-19, 10:34 AM
RE: [DG11] autopilot oscillates back and forth - Derek - Raymarine - Moderator - 04-09-19, 03:52 AM
RE: [DG11] autopilot oscillates back and forth - Kmac - 04-09-19, 08:09 AM
RE: [DG11] autopilot oscillates back and forth - Derek - Raymarine - Moderator - 04-09-19 10:02 AM
|
User(s) browsing this thread: 1 Guest(s)