Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA11] Radar over lay with ais
05-22-19, 02:54 PM (This post was last modified: 05-24-19 10:03 AM by Chuck - Raymarine - Moderator.)
Post: #4
RE: [CA11] Radar over lay with ais
Bdv240,

Overlaying the Radar application's radar plot with waypoints remains on the backlog of high priority features to be included within a LightHouse 3 software update. Overlaying the Radar application's radar plot with waypoints may be accomplished via the command sequence MENU->TARGETS->AIS SETTINGS->SHOW AIS TARGETS IN RADAR. Within the Radar application, AIS targets may be displayed within the application's Targets screen (MENU->TARGETS->AIS) ... and only then when the AIS tab has been selected. This feature further requires all of the following:
- the system has been interfaced to compatible radar transducer
- the system has been correctly interfaced to an operational AIS receiver / transceiver
- the system has acquired a GPS position FIX
- the system has been interfaced to a source of heading (not to be confused with COG) data.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA11] Radar over lay with ais - Bdv240 - 05-21-19, 03:25 AM
RE: [CA11] Radar over lay with ais - Chuck - Raymarine - Moderator - 05-22-19 02:54 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us