The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Autopilots v / [LW] [LW11] S3 Autopilot with ST70 Pilot controlle

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[LW] [LW11] S3 Autopilot with ST70 Pilot controlle
06-11-19, 06:54 AM (This post was last modified: 06-12-19 07:03 AM by Louise - Raymarine - Moderator.)
Post: #1
Lumumba Offline
Junior Member
**
 		Posts: 2
Joined: May 2019
Reputation: 0
[LW11] S3 Autopilot with ST70 Pilot controlle
Hi,
I’ve got an S3 Pilotcomputer that was connected to a ST6002 Pilot Controller. Unfortunately the ST6002 took water over Winter (it’s 14 years old) and dosen’t work anymore. I had a contact to Raymarine afterssales that a ST70 pilot control could also be connected. I found a new device on eBay and tried to connect it. I have an IC5 because I had I70 displays mounted an R52131 converter. I tried first to connect th ST70 on the IC5. It started up and then said it couldn’t,find the auto pilot. I then tried to connect it to the seatalk on a E25049 connector. Since then when I connect it it show’s the ST70 logo and then the display goes blank. What I’m trying find out, is if the ST70 controller has a problem or if my wiring is wrong. How can the ST70 be tested?
Hand drawn shema attached
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[LW11] S3 Autopilot with ST70 Pilot controlle - Lumumba - 06-11-19 06:54 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication