[CA11] E120 Crash when set to 38400 BAUD

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[CA] [CA11] E120 Crash when set to 38400 BAUD - AIS is NMEA 0183

06-18-19, 02:56 PM (This post was last modified: 06-20-19 11:53 AM by Chuck - Raymarine - Moderator.)

Post: #1

ckroeger Offline

Junior Member

Posts: 3
Joined: Jun 2019
Reputation: 0

[CA11] E120 Crash when set to 38400 BAUD - AIS is NMEA 0183

Hi,
I have an AIS650 and two E120 Classics. The AIS650 is wired via NMEA0183 and connected to the Repeater E120 Classic. I can verify that the AIS650 is working.
However, when I set the communications ti 38400 BAUD, the repeater starts to screen flicker and then freezes. In the process, it does populate the AIS traffic in the area.
I have reset the E120's many times, their software is up to date. I have also updated the AIS650's software to the current version.
The problem is amplified when many AIS targets are around me.
How do I address this problem?
Should I switch to the SeaTalkng system? If so, how do I rewire it?
Thank you in advance.

« Next Oldest | Next Newest »

Messages In This Thread

[CA11] E120 Crash when set to 38400 BAUD - AIS is NMEA 0183 - ckroeger - 06-18-19 02:56 PM

RE: [CA11] E120 Crash when set to 38400 BAUD - AIS is NMEA 0183 - Chuck - Raymarine - Moderator - 06-20-19, 12:46 PM

RE: [CA11] E120 Crash when set to 38400 BAUD - AIS is NMEA 0183 - ckroeger - 06-25-19, 09:09 AM

RE: [CA11] E120 Crash when set to 38400 BAUD - AIS is NMEA 0183 - Chuck - Raymarine - Moderator - 06-25-19, 09:35 AM

RE: [CA11] E120 Crash when set to 38400 BAUD - AIS is NMEA 0183 - lotharjt - 07-01-19, 09:07 AM

RE: [CA11] E120 Crash when set to 38400 BAUD - AIS is NMEA 0183 - Chuck - Raymarine - Moderator - 07-01-19, 11:08 AM

User(s) browsing this thread: 1 Guest(s)