Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Replacing a Robertson AP3000 Auto pilot
06-25-19, 08:52 AM
Post: #2
RE: [CA11] Replacing a Robertson AP3000 Auto pilot
Welcome to the Raymarine Forum Brian,

As you have suggested, the T70162 Evolution EV-400 Power would be recommended for a Robertson RPU 160 hydraulic drive.

Should you elect to one day interface the autopilot to the Garmin system, then it would be recommended that an Actisense NGW-1-ISO-STNG data bridge be used to interface the Evolution autopilot the Garmin chartplotting system. The NGW-1-ISO-STNG's NMEA 2000 cable will be plugged into a spur socket (white) within the backbone which will be interfacing the Evolution autopilot components to one another. The Actisense NGW-1-ISO NMEA 0183 to NMEA 2000 data bridge features a pair of NMEA 0183 input and output leads. The NMEA 0183 RXA and RXB leads of the Actisense NGW-1-ISO NMEA 0183 to NMEA 2000 data bridge will be interfaced to the NMEA 0183 OUT+ and NMEA 0183 OUT- terminals respectively of the Garmin charplotting system to permit the Evolution autopilot to receive navigational data associated with a Go To or Follow route command executed via the Garmin chartplotting system.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA11] Replacing a Robertson AP3000 Auto pilot - Chuck - Raymarine - Moderator - 06-25-19 08:52 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)