Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[LW] [LW11] AIS full data not appearing
08-12-19, 03:53 AM
Post: #4
RE: [LW11] AIS full data not appearing
Dear Mr Plover,

Thank you for your post.

This is not an AIS unit we have tested with the Axiom but there is no reason why you should not see the data. The Lighthouse 3 software is repeating data it is seeing on the network - what revision of Lighthouse do you have on the Axiom? HOMESCREEN> SETTINGS - the revision of software is listed under the Axiom description, the most up to date version is Lighthouse 3.10.42.

Have you got the STng backbone correctly setup? Are there terminators in each end of the backbone? How are you powering the backbone?

Can you send a screenshot in of the data you are seeing to assist us.

Have you connected the AIS unit to a PC to ensure the the AIS unit is Rx and TX correctly with all necessary data, the manufacturer would have provided the software for this, usually we use ProAIS2 but I am unsure if your AIS unit also uses the same software?

Many Thanks
Louise
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [LW11] AIS full data not appearing - Louise - Raymarine - Moderator - 08-12-19 03:53 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)