[CA] [CA11] NC2 charts

[Chuck - Raymarine - Moderator]

Welcome to the Raymarine Forum John,

Please note that I have been unable to duplicate the reported issue when using my NC2 Chart Card within a system featuring Axiom / Axiom Pro MFDs running LH3 v3.10.39 software. It would be recommended that the MFD's software be updated and that a Power ON Factory Reset procedure be executed. There were many odd issues related to the LH3 v3.8.x and v3.9.x software, many of which, were corrected through execution of the Power ON Factory Reset procedure. That said, LH3 v3.10.39 was released earlier this week. It is recommended that this software be installed within the system's MFDs and that the Power ON Factory Reset procedure then be executed on each of the system's MFDs to correct the reported behavior.