Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Axiom 9 and eS78 quit talking
08-05-19, 07:07 PM
Post: #3
RE: [CA11] Axiom 9 and eS78 quit talking
Hi Chuck,
I upgraded my Axiom 9 to version 3.10.42, accomplished a factory reset on both units.
After powering both units up again. I still have to have the eS78 as data master for the NEMA0183 data, not a problem for me.
After about 10-15 minutes I shut the system down. Upon powering up system, I noticed that upon accessing the chart screen on the Axiom, it would go into a continuous loop of rebooting. going from a screen displaying "AXIOM" to "LIGHTHOUSE 3" to almost displaying only numbers on the data page before returning to AXIOM.
I have not tried to access any other pages after the up-grade set up was accomplished.

Doug M
sv Rebecca Leah
C&C Landfall 39
Puget Sound
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA11] Axiom 9 and eS78 quit talking - dmtjoy - 08-05-19 07:07 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)