The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Instruments v / [CA] [CA11] ST60 Speed Display Problem

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] ST60 Speed Display Problem
07-30-19, 09:48 AM (This post was last modified: 08-02-19 12:58 PM by Chuck - Raymarine - Moderator.)
Post: #1
WinniBoater Offline
Junior Member
**
 		Posts: 1
Joined: Jul 2019
Reputation: 0
[CA11] ST60 Speed Display Problem
There is an ST60 Speed display on my sailboat that just started having a problem the other day. While the boat is in motion, the display shows 0.0. The paddle wheel is clear of any obstruction and rotates freely. If I disconnect the green wire from the back of the unit and reconnect it, the display shows a value. But, within a few seconds, the displayed value decreases to 0.0 even though the boat is still under way.

Is this repairable or should the unit be replaced? IS the ST60 still sold? If not, will a new generation Speed display fit the same pod and be compatible with the other ST60 instruments?
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA11] ST60 Speed Display Problem - WinniBoater - 07-30-19 09:48 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication