The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error





Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[LW] [LW11] Autopilot - drive stopped
07-31-19, 12:34 PM (This post was last modified: 08-08-19 02:46 AM by Louise - Raymarine - Moderator.)
Post: #1
[LW11] Autopilot - drive stopped
Hi,

I have an autopilot setup consisting of the following
- X10 Smartpilot
- ST70 pilot head
- L&S RV2 hydraulic pump

I frequently get the "Drive Stopped" error. When the autopilot is not working hard it can run for an hour or two before it stops, but often it stops within minutes of engaging the pilot. I have been studying these forums for solutions but I havent been able to isolate the problem yet.

Today I disconnected the motor from the X10, put it in auto and read 6.5 V +- 0.1 V output from the X10. Is this right or should the X10 output more to the motor?

Any help would be greatly appreciated :)
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[LW11] Autopilot - drive stopped - First35 - 07-31-19 12:34 PM

Forum Jump:


User(s) browsing this thread: 2 Guest(s)