Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[JH] [JH11] ITC-5 Wind Troubleshooting
09-05-19, 01:41 PM (This post was last modified: 09-05-19 01:42 PM by John - Raymarine - Moderator.)
Post: #2
RE: [JH11] ITC-5 Wind Troubleshooting
Hello IWITTY,

Thanks for your post.

1. The yellow wire does carry the speed signal.
2. New Spade connectors can be ordered with part number Q085
3. New wind cable can be ordered separately as well with part number A28162 for 98ft and a new top of the mast connector on one side of the cable.
4. If trying to run just the yellow cable a Cat 5 cable is a bit too small but you could get the amount of 18 awg electrical wire to just test that one.

We are not offering any other wind solutions other then the model that goes through an ITC-5 or an I60 to get into an NG network.

Best regards
John
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [JH11] ITC-5 Wind Troubleshooting - John - Raymarine - Moderator - 09-05-19 01:41 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)