The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Autopilots v / [CA] [CA11] Power supplied to S2 course computer

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Power supplied to S2 course computer
09-10-19, 10:10 AM (This post was last modified: 09-11-19 11:52 AM by Chuck - Raymarine - Moderator.)
Post: #1
ghivancich Offline
Junior Member
**
 		Posts: 2
Joined: Mar 2017
Reputation: 0
[CA11] Power supplied to S2 course computer
I am curious about the proper power supply to the S2 course computer.
I have the installation manual, "SmartPilot Series Commissioning Guide".
In this guide, on page 5, under cable length, for distribution panel to SmartPilot computer, is given a confusing list of numbers. I don't get it.
I have a 12 volt, type 1, linear drive. The distance from the distribution panel to the computer is approximately 15 feet one way. It is currently served by a 30 amp circuit breaker with 10 gauge wire to the computer. The wire from the computer to the drive unit is 12 gauge running approximately 10 feet.
Does this seem to be adequate, or should this be upgraded?
I have not experienced any problems with this arrangement but I don't want to be causing a problem from inadequate wiring.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA11] Power supplied to S2 course computer - ghivancich - 09-10-19 10:10 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication