Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[TG11] Interfacing with Yanmar 3JH40 motor
09-10-19, 06:23 PM (This post was last modified: 09-11-19 11:46 AM by Chuck - Raymarine - Moderator.)
Post: #1
Wink [TG11] Interfacing with Yanmar 3JH40 motor
installing two new Yanmar 3JH40 engines on a Catamaran and wish to interface them to the Raymarine plotter (eS127).
This is a new engine and information is not available on the Raymarine ECI site. Can you confirm if this engine can interface direct to the Raymarine plotter exchanging engine monitoring information in NEMA format direct to the Seatalking data bus – or not, and if an ECI-100 is required (I understand it may not be with this new Yanmar NEMA interface.

Can you please confirm if this is possible and what connectors are needed.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[TG11] Interfacing with Yanmar 3JH40 motor - Kmarineltd - 09-10-19 06:23 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us