[CA11] New Axiom user questions

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[CA] [CA11] New Axiom user questions

10-08-19, 11:19 AM (This post was last modified: 10-08-19 01:26 PM by Chuck - Raymarine - Moderator.)

Post: #1

RockBottom Offline

Junior Member

Posts: 11
Joined: May 2019
Reputation: 0

[CA11] New Axiom user questions

I have just installed an Axiom 9 with a RV100 transducer. Put it on the water yesterday for the first time and seem to be getting interference on the sonar. Attached are some screenshots. It looks like I am leaving a trail of fish on the Realvision and the sonar isn't clean at all. The gain was set to auto. There were no other devices on that could cause interference and I did turn off the engine but there was no change. On installation I installed the drain wire on the negative bus with the negative power lead. Any advice on what is causing this issue?

Attached File(s) Thumbnail(s)

« Next Oldest | Next Newest »

Messages In This Thread

[CA11] New Axiom user questions - RockBottom - 10-08-19 11:19 AM

RE: [CA11] New Axiom user questions - Chuck - Raymarine - Moderator - 10-08-19, 03:49 PM

RE: [CA11] New Axiom user questions - RockBottom - 10-28-19, 06:43 AM

RE: [CA11] New Axiom user questions - Chuck - Raymarine - Moderator - 10-28-19, 08:17 AM

RE: [CA11] New Axiom user questions - RockBottom - 10-28-19, 08:22 AM

RE: [CA11] New Axiom user questions - Chuck - Raymarine - Moderator - 10-28-19, 09:01 AM

User(s) browsing this thread: 1 Guest(s)