The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error





Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[DG] [DG11] type 3 hydraulic linear
11-05-19, 06:24 PM (This post was last modified: 11-07-19 10:50 AM by Derek - Raymarine - Moderator.)
Post: #1
[DG11] type 3 hydraulic linear
I am hoping to install a type 3 drive into a cramped area. There is plenty of clearance fore and aft and to each side, however I only have 115mm of vertical space to work with. Your drawing shows an 80mm profile but does not indicate where the hydraulic fittings are. Are they mounted on top?
If there isn't enough clearance is it safe to mount the pin connecting the ram end to the tiller arm upside down?
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[DG11] type 3 hydraulic linear - shparrot - 11-05-19 06:24 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)