Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Interfacing E80 Classic with RL80C
01-08-20, 11:22 AM (This post was last modified: 01-08-20 12:45 PM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] Interfacing E80 Classic with RL80C
Are an E80 Classic MFD with RL80C compatible? Could they be interfaced via a HSB or Seatlk hs adapter (if it exists)? Or with a Seatalk 2 to Seatalk1? The E80 would be used as the main unit and the RL80C as the slave.
Find all posts by this user
Quote this message in a reply
01-08-20, 01:45 PM
Post: #2
RE: [CA11] Interfacing E80 Classic with RL80C
Welcome to the Raymarine Forum hgispert,

Unfortunately, E-Series Classic MFDs (E80, E120) are not designed to be interfaced to hsb/hsb2 Pathfinder Series Displays ... and certainly not in a manner which would support the degree of resource and data sharing which you have inquired about. While it is possible to interface a hsb/hsb2 Pathfinder Series Display to the same SeaTalk bus to which an E-Series Classic MFD (via its SeaTalk/Alarm Cable) has also been interfaced, communications would be limited to alphanumeric, GPS, instrument, navigational, and system status data between these systems. Correspondingly, it is not possible for E-Series Classic MFDs to share graphical data such as cartography, radar, fishfinder, or Sirius Marine Weather with any product other than another E-Series Classic MFD.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)