Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[DG] [DG11] Temperature from Itc5 is not shown in Mfd
02-22-20, 04:55 PM (This post was last modified: 02-24-20 02:05 PM by Chuck - Raymarine - Moderator.)
Post: #1
[DG11] Temperature from Itc5 is not shown in Mfd
Airmar Dst triducer sensor (speed, Deep, temp) is tested to be ok, connected to Raymarine Itc5 converter
Led indicators in Itc5 is ok, Itc5 connected with Seatalkng converter terminal to Mfd Axiom Pro S
However only speed and depth i displayed correctly in Mfd Axiom Pro
Only max temperature is displayed in Mfd, not current temperature
Does anyone have any idea ?

/JanneHson
Find all posts by this user
Quote this message in a reply
02-25-20, 06:44 AM
Post: #2
RE: [DG11] Temperature from Itc5 is not shown in Mfd
Hi JanneHson

Thankyou for your enquiry,

There should be no issue with this as far as we know, a couple of things to check,

Go into multiple Data Source selection in the AXIOM and select the DST as source of Speed, depth and Temperature - even if it is selected already, make sure that you RESELECT it again to be sure that the itc-5 that is the source for the data.

The other alternative is to measure the resistance across the temperature thermocouple wires, 10k ohm is about 24 degrees Celcius.

Regards
Derek
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)