Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] not recognizing transducers
03-08-20, 12:02 PM (This post was last modified: 03-09-20 02:49 PM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] not recognizing transducers
I have an Axiom 9 part number E70367 with an RV100 transducer
trying to add a P66 Transducer part number E66054 using Y cable Part Number A80492.

when using the Y cable the unit doesnt recognize either transducer
is there a setting I need to change?
Find all posts by this user
Quote this message in a reply
03-09-20, 02:53 PM
Post: #2
RE: [CA11] not recognizing transducers
Welcome to the Raymarine Forum DVRoehl,

It is recommended that you ensure that your MFD has been updated with LightHouse 3 v3.11.42 or later software and that after having done so, that a Power ON Factory Reset Procedure has been performed to the MFD, and that the MFD's settings have been manually reconfigured, rather than restored from a saved settings file. Should the problem persist thereafter, then it would be recommended that the Y-Cable be returned to Raymarine for replacement.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)