Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CC11] Seatalk to NMEA 2000
05-03-20, 08:24 PM (This post was last modified: 05-04-20 03:17 PM by Chris - Raymarine - Moderator.)
Post: #1
[CC11] Seatalk to NMEA 2000
I have been reading a few of the topics on seatalk 1 to NMEA 2000. I have a ST 60m network but no seatalkng instruments. My newer instruments are NMEA 2000. As I understand it I must buy the converter and install that as part of the backbone, blank off the seatalkng plugs and simply use the converter as a spur T connection. The converter translates all seatalk 1 to NMEA format??? And all is well? I can then remove the multiplexer to simplify a section. that device seems to be acting up and I have lost the position data from the system.
1/ The converter is a backbone spur talking seatalk 1 info into the 2000 system?
2/ Another spur feeds an Actisense 2000 to 0183 converter for position data to the radios.
3/ Spur takes info from the SiTex AIS transceiver for vessel info to the 2000 and shares with the last.
4/ a Lowrance MFD

So purchase the E22158 package, plug in the seatalk 1 to the yellow position, cut off one end of the backbone cables and convert them to devicenet micro C connections?

Separately, will the Lowrance HDS 7 be able to use the depth and heading and wind data?
Find all posts by this user
Quote this message in a reply
05-08-20, 12:52 PM (This post was last modified: 05-08-20 01:08 PM by Chris - Raymarine - Moderator.)
Post: #2
RE: [CC11] Seatalk to NMEA 2000
Hello Arcflash,

Could you provide a full list if every piece of equipment in this installation?

Chris,
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)