Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
chart radar overlay
07-23-16, 10:19 AM
Post: #1
chart radar overlay
when I try to syn the ranges on the chart radar overlay on my e120 classic it seems to show that the range that is syn. is half of the upper range shown. why are two ranges shown and why is one half of the other? thanks , Jim
Find all posts by this user
Quote this message in a reply
08-01-16, 03:36 PM
Post: #2
RE: chart radar overlay
Hello Jim,
On an E120 Classic MFD when you use chart/radar sync you will see that the radar page will show half the range of what the chart shows, but they are in fact sync'd.
Example; the chart shows a range of 6nm and the radar will show a range of 3nm.
The reason being is that the radar range is measured from the center to the top, center to bottom, center to sides whereas the chart range is all encompassing.
Find all posts by this user
Quote this message in a reply
08-02-16, 07:17 PM
Post: #3
RE: chart radar overlay
sorry about the double post , didn't think the first one worked . thanks for the reply . Jim
Find all posts by this user
Quote this message in a reply
08-03-16, 04:11 PM
Post: #4
RE: chart radar overlay
Your'e welcome.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us