Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Ray215 Squelch
08-24-16, 04:48 PM
Post: #1
Ray215 Squelch
My squelch cannot be turned low enough. At the minimum the display shows two bars and nothing comes through. It cannot be turned down to a point where the radio makes static like it did when it was new. Transmission works fine. Is there a way to adjust the squelch level lower or do I need to send it to repair or is it hopeless?
Find all posts by this user
Quote this message in a reply
08-25-16, 08:14 AM
Post: #2
RE: Ray215 Squelch
Welcome to the Raymarine Forum jstenzel,

Based upon the symptoms reported, the radio's receiver circuitry would seem to have suffered a failure and it would be recommended that the Ray215 be replaced (typically w/Ray50 or Ray60) or sent to Raymarine’s Product Repair Center to be bench checked / serviced.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us