Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
replacing st 40 depth and wind and also st50 speed
09-28-16, 01:56 PM
Post: #1
replacing st 40 depth and wind and also st50 speed
I would like to replace my existing instruments st 40 wind and st 40 depth with i60 wind and i50 depth and replace the st 50 speed with the i50. Can I use the existing transducers for each? Any other cables etc. needed?
Find all posts by this user
Quote this message in a reply
09-28-16, 03:43 PM
Post: #2
RE: replacing st 40 depth and wind and also st50 speed
Welcome to the Raymarine Forum Chuck,

It is indeed possible to interface a Rotavecta wind transducer to an i60 Wind Instrument and then calibrate the wind transducer. It is additionally possible to interface the depth and speed/temp transducers from ST50 instruments to i50 instruments. As the ST50 depth and speed/temp transducer cables were terminated with plugs rather than bare leads, these plugs will need to be removed, 1/8" female blade connectors will need to be attached to the transducer leads, and then the transducer leads will be connected to the matching colored terminals of the i50 instruments.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)