Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
SmartPilot S2 to StNG network design
01-30-17, 07:34 PM (This post was last modified: 01-31-17 10:42 AM by Chuck - Raymarine - Moderator.)
Post: #1
SmartPilot S2 to StNG network design
Hi,

I would like to know if the following network design will work. I have read everything I could find. Basically I have a new StNG network and want to integrate my S2/ST6002 autopilot so that it can communicates to my a65 as well as sharing heading data to StNG. Note that in my design the SmartPilot does not provide power to the ST6002 who is in turn powered by the St1-StNG converter. See attached drawing below.

[Image: attachment.php?aid=738]
Find all posts by this user
Quote this message in a reply
01-31-17, 10:40 AM (This post was last modified: 01-31-17 10:41 AM by Chuck - Raymarine - Moderator.)
Post: #2
RE: SmartPilot S2 to StNG network design
Welcome to the Raymarine Forum Godind,

Your diagram appears to be correct for interfacing the products shown.
Find all posts by this user
Quote this message in a reply
01-31-17, 10:19 PM
Post: #3
RE: SmartPilot S2 to StNG network design
Thank you Chuck. Much appreciated.
Find all posts by this user
Quote this message in a reply
02-01-17, 08:47 AM
Post: #4
RE: SmartPilot S2 to StNG network design
You're welcome.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 2 Guest(s)